Currently using a platinum pro plug in on my rb25 r33. I have bought a ross 12t crank trigger kit using cherry sensors for crank trigger and cam home.
Planning to use the factory cas wiring for 12v and signal wires.
Can i use the cas ground(earthed to chassis) or do i have to earth the sensors to the ecu?
Do i need to wire in a 2.4k resistor between the 12v and signal wires as suggested by the sensor manufacturer?
Kind regards Harris
Questions about the Platinum Pro Plug-in ECU's? Ask here.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests