Elite 1000

Questions about the Elite Series ECU's? Ask here.
Posts: 3
Joined: Sat Aug 05, 2017 10:00 pm

Elite 1000

Postby Rx7fduk » Sat Mar 17, 2018 7:48 am

Ok so a couple of newbie questions hope you don't mind,
In the target Lambda table Lambda 1.00 is 14.7 correct so then lower numbers ie 0.90 would be 13.2 and so on, why is it when I enter a lower number the table turns red as this equals leaner doesn't it?

Lastly in base fuel map the numbers are % but whats it a % of?

Hope these questions make sence


User avatar
Haltech Staff
Posts: 2825
Joined: Tue Feb 07, 2012 12:45 pm
Location: Sydney, Australia

Re: Elite 1000

Postby HaltechMatthew » Mon Mar 19, 2018 2:41 pm

It is only a colour gradient. Red does not mean bad. Lower numbers are richer.

The base number or Volumetric Efficiency (VE). It is a percentage of air that entered the engine based on the engine displacement you entered. The ECU then injects the right amount of fuel based on the injector data you have entered. Most ECUs use this method these days because it is simpler to initially fire up an engine from scratch.

Return to “Elite Series”

Who is online

Users browsing this forum: No registered users and 2 guests