Questions about the Elite Series ECU's? Ask here.
2 posts • Page 1 of 1
It is time to update the E6k on the rail. I am looking at the Elite 750. I run a Haltech S3 hall effect sensor off a disk on the crank to get trigger and home signal. this ecotec 2.0 has no cam sensor, and no crank wheel. will this sensor integrate in to the needed signal for the 750?
- Haltech Staff
- Posts: 2825
- Joined: Tue Feb 07, 2012 12:45 pm
- Location: Sydney, Australia
Yes it will work and you will set the Trigger to Generic Standard Half Cycle Sync. It will allow up to semi sequential fuel and waste spark ignition.
Who is online
Users browsing this forum: No registered users and 2 guests