I have an Elite 1500 and a P&P adaptor loom for a VVT engine car. It is fitted with a 36-2 trigger wheel. I'm using the base map for MX5 VCT as the starting point, and want to set up the triggering and check the timing.
I believe I need to use a 'Generic multi tooth' and set the teeth count. The options in the Haltech software for the trigger specify the type of home that will be used. The standard home signal settings in the Mx5 BP NB VCT map refer to them as 'custom' but don't describe them. What trigger type and home type should I be using?
If you have a set of settings you can share that support the 36/2 trigger wheel in a VCT NB Mx5 it would be appreciated a lot.
Questions about the Elite Series ECU's? Ask here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests