Page 1 of 1

Elite 1500 install questions

Posted: Sun Apr 04, 2021 6:58 pm
by Everkain
Hey all, I am currently installing my elite 1500 w/ ic-7 on my evo 8 and I have a few questions. This is my first time installing a stand alone. I have the 1500 installed using the plug and play harness. I installed the ic-7 and ran the wire to the single wideband hub and the hub is connected to the 1500. All of that seems correct, but my questions are spout the sensors.

I have the haltech oil pressure, oil temp, fuel pressure, ethanol content, and iat that need to be hooked up still. First off, the sensors came with the pigtails, but without any wires. Am I supposed to build the wiring harnesses for each sensor? Secondly, where do you plug all the sensors in to on the 1500? There is only 1 usb and 1 avi port on the 1500. Any help would be great. Thanks

Re: Elite 1500 install questions

Posted: Mon Apr 05, 2021 12:26 am
by Orangeblue
Check the Quick Start Guide... ... 8-5-speed/

If you have the p&p adapter and want to use additional sensors you'll have to make your own harness.

Since it's your first time, i'd suggest to read up on how to do this kind of thing or watch some vids here: