Elite 2500 ECR output - can set to high/+12V ?

Questions about the Elite Series ECU's? Ask here.
User avatar
Halfwalker
Posts: 26
Joined: Sat Dec 07, 2019 1:44 am

Elite 2500 ECR output - can set to high/+12V ?

Postby Halfwalker » Mon Sep 26, 2022 2:55 am

I have an Elite 2500 in a 1994 Toyota Supra TT, and was planning on using the ECR function via pin A25 to control the EFI Main Relay. That relay requires a +12V signal to activate, as the other end of the coil is connected to GND.

But, I can't seem to find anywhere in NSP to set it to Active-HIGH, and of course it seems to default to Active-LOW.

Is it possible to configure the ECR function to output a +12V when active ?

User avatar
blakebonkofsky
Posts: 450
Joined: Sun Aug 02, 2015 2:58 am

Re: Elite 2500 ECR output - can set to high/+12V ?

Postby blakebonkofsky » Mon Sep 26, 2022 4:40 am

No, DPOs can only switch to ground. You could set up a generic function and use a Stepper or DBW output if you have those available, as they can switch to +12v.


Return to “Elite Series”

Who is online

Users browsing this forum: No registered users and 3 guests