Questions about the Elite Software Programmer? Ask here.
2 posts • Page 1 of 1
When making custom gauge pages utilizing bar and dial display gauges, is there a way to change the min and max display range? I use a car PC always connected to my 2500 ecu, and the ranges are always so wide for bar and dial gauges. Example, my oil pressure typically maxed out at 120psi during a cold start idle, 80-90 psi warm in high rpm. However, in dial or bar gauge displays on the screen will show 0-450 psi, making for way too much resolution of the gauge and harder to notice if its out if its range of typical operation. Is it possible to set it down to something like 0-130? Same goes for all my other similar parameters running digital gauges like fuel pressure, speedo, rpm (showing 20k...) etc.
Who is online
Users browsing this forum: No registered users and 2 guests