Dial Gauge Page ESP - Min/Max Settings

Questions about the Elite Software Programmer? Ask here.
ItzGenX
Posts: 13
Joined: Thu Feb 10, 2011 7:50 am

Dial Gauge Page ESP - Min/Max Settings

Postby ItzGenX » Mon Dec 16, 2019 11:00 am

When making custom gauge pages utilizing bar and dial display gauges, is there a way to change the min and max display range? I use a car PC always connected to my 2500 ecu, and the ranges are always so wide for bar and dial gauges. Example, my oil pressure typically maxed out at 120psi during a cold start idle, 80-90 psi warm in high rpm. However, in dial or bar gauge displays on the screen will show 0-450 psi, making for way too much resolution of the gauge and harder to notice if its out if its range of typical operation. Is it possible to set it down to something like 0-130? Same goes for all my other similar parameters running digital gauges like fuel pressure, speedo, rpm (showing 20k...) etc.

User avatar
HaltechMatthew
Haltech Staff
Posts: 3304
Joined: Tue Feb 07, 2012 12:45 pm
Location: Sydney, Australia
Contact:

Re: Dial Gauge Page ESP - Min/Max Settings

Postby HaltechMatthew » Mon Dec 16, 2019 3:02 pm

There isn't currently, but with new software coming soon I would be holding out.


Return to “Elite Software Programmer (ESP)”

Who is online

Users browsing this forum: No registered users and 1 guest