Elite 2500 rev limit/hard cut problem

Questions about the Elite Software Programmer? Ask here.
Bjørn-Tore
Posts: 1
Joined: Thu May 07, 2020 7:27 am

Elite 2500 rev limit/hard cut problem

Postby Bjørn-Tore » Thu May 07, 2020 7:56 am

I have an ej207 that runs on the elite 2500. I don't get the hard cut to work. have rev limit set to 8000, but it goes about 8400 before it cuts, when it comes down to 8000 it pops up to 8400 again. no bangs or anything. seems like the ecu is slow on reaction a bit. it behaves almost the same neither I choose ignition or injection cut, sort or hard cut.

Cut Method: ignition
Cut type: hard cut
Hysteresis 10rpm

Return to “Elite Software Programmer (ESP)”

Who is online

Users browsing this forum: No registered users and 2 guests