Page 1 of 1

oil pressure calibration

Posted: Sat Jan 09, 2021 9:07 pm
by Manuelpro
Hello,
When I set the pressure units in bar in the software esp2.45.00 and I want calibrate my oil pressure sensor, the table offers me volts / absolute bar and not volts / bar.
So for 0 bars, I get 1.013 bars.
But if for example, I set the pressure units in kpa then there I have volts / kpa, not volt/absolute kpa.
which way to obtain a scale in bar?

Re: oil pressure calibration

Posted: Sun Jan 10, 2021 1:36 am
by JimKden
The display units will be those you have selected for display. The calibration units are converted to the selected display scale. You will have to build the calibration table to the units on the calibration page.