oil pressure calibration

Questions about the Elite Software Programmer? Ask here.
Manuelpro
Posts: 3
Joined: Tue Mar 31, 2015 5:26 am

oil pressure calibration

Postby Manuelpro » Sat Jan 09, 2021 9:07 pm

Hello,
When I set the pressure units in bar in the software esp2.45.00 and I want calibrate my oil pressure sensor, the table offers me volts / absolute bar and not volts / bar.
So for 0 bars, I get 1.013 bars.
But if for example, I set the pressure units in kpa then there I have volts / kpa, not volt/absolute kpa.
which way to obtain a scale in bar?

JimKden
Posts: 560
Joined: Wed Jan 12, 2011 3:28 am

Re: oil pressure calibration

Postby JimKden » Sun Jan 10, 2021 1:36 am

The display units will be those you have selected for display. The calibration units are converted to the selected display scale. You will have to build the calibration table to the units on the calibration page.


Return to “Elite Software Programmer (ESP)”

Who is online

Users browsing this forum: No registered users and 3 guests