Prelude H22 trigger settings/getting started

Questions about the Elite Software Programmer? Ask here.
Chris_didthis
Posts: 1
Joined: Tue Feb 16, 2021 12:21 am
Location: Melbourne

Prelude H22 trigger settings/getting started

Postby Chris_didthis » Tue Feb 16, 2021 12:46 am

Hi Everyone, I Couldn't find much info on the H22 when i was trying to setup the trigger page and the OBD1 Honda basemap didn't work for me so i just thought id share the trigger settings i used to get my h22 running.

Image

I saw a two different posts that had clashing information but you want the trigger and home sensors to both be setup as reluctors with a rising edge.
For me my TDC offset angle was 445 (saw on another post that they set it to 76)

For my ignition setup the settings are as followed

Image

Set as a distributor with a rising edge

For Coolant and Air Temp calibration i used the values found in this article: https://support.haltech.com/portal/en/k ... eed_Sensor
Just make sure that pull up is enabled

I was using Hondata before this with a p72 (integra) ecu where you cannot calibrate the sensors so my thinking was if Hondata read those sensors fine then the B and H series engines must use similar sensors.
The same can be said for the Trigger type, I've selected the B18c trigger type with the same thought process.

Of course please check the TDC offset angle table as i needed to adjust mine. To check timing there should be a 15 degree timing mark on the flywheel

And one other little bit of info is that the VSS is a Hall effect sensor with a falling edge, if its set as a reluctor sensor the vss will jump around and you may run into a situation where the injectors dont turn off for whatever reason.

Anyways, hope this helps anyone planning on using Haltech on a H series!

V_gentleman
Posts: 3
Joined: Sat Nov 27, 2021 10:35 pm

Re: Prelude H22 trigger settings/getting started

Postby V_gentleman » Sat Nov 27, 2021 10:44 pm

Hi thankyou very much for the info - have bought... a while ago now a civic ek with a h22a swap.

Got a registered dealer to install an elite 550 with loom etc.

And now waited 8-9 months to get it home ... gave up and paid to get it towed to my place (not running).

I have a lot of questions ....never done this haltech before, but OK enough mechanically for the basics.

Got your basics setup in trigger etc. but weird 'greyed out' settings eg. AC Signal coupling? (don't sound right?) for Trigger signal and home signal.

No idea how to setup a basic TDC offset angle table, could you post a screen shot of yours, would that be helpful?

JimKden
Posts: 614
Joined: Wed Jan 12, 2011 3:28 am

Re: Prelude H22 trigger settings/getting started

Postby JimKden » Sun Nov 28, 2021 1:58 am

The Haltech channel on Youtube has a training video on setting up the angle. I tells how to do it very well much better than I could or in a bunch of posts here.

V_gentleman
Posts: 3
Joined: Sat Nov 27, 2021 10:35 pm

Re: Prelude H22 trigger settings/getting started

Postby V_gentleman » Mon Nov 29, 2021 8:31 pm

Is it possible to somehow rest those 'greyed out' settings in trigger type settings - I really do not think it will run. The auto electrician set this up wrong from the start... unfortunately.


Return to “Elite Software Programmer (ESP)”

Who is online

Users browsing this forum: No registered users and 2 guests