Fuel level not working

[Notniceek]

[list=][/list] since I updated my Ic7 to the latest software and firmware the fuel level stop working its reading voltage but the fuel level remains at 0

[JanVuo]

Same happened here. I updated the latest firmware 1.11.7 and fuel reading shows zero after that.
Worked fine before update so it must be a bug
Sensor is on AVIP 4 (pin 21) but it stopped reading that. This must be reported directly to Haltech

[JanVuo]

Same happened here. I updated the latest firmware 1.11.7 and fuel reading shows zero after that.
Worked fine before update so it must be a bug
Sensor is on AVIP 4 (pin 21) but it stopped reading that. This must be reported directly to Haltech

Talked to haltech support (thanks for them) and the problem (at least for me) was that when i upgraded the latest 1.11.7 software (which include also firmware update), it changed my fuel level function from 90-0 ohm to 240-33 ohm and also the voltage limits for that just disappeared.
Changed back to 90-0 and voltages about how it was and it shows the reading now.

So check if it has changed first. If it has messed up your calibration, it looks like this. Channel list shows your old sensor setup and calibration shows something else.