ESP to NSP errors appearing.

Questions about the Nexus Series ECU's? Ask here.
fabs_123
Posts: 1
Joined: Sun Aug 09, 2020 4:35 pm

ESP to NSP errors appearing.

Postby fabs_123 » Mon Jan 24, 2022 10:03 pm

Hi all I am new to this forum so here goes.

I downloaded the new NSP software to use on my current Elite 2500.

I now get 6 errors
Question 1:
4 errors are all practically the same as my old ESP had engine protection level (least severe as disabled.
on the old ESP had no issue and no errors, but NSP is throwing error cos level 1 is disabled.
Should I just enable level 1 and if so what setting do I use?

Question 2:
On the new NSP for the ignition Correction Attack and decay.T
the channel from the old ESP has it set at gear for one axis.
On NSP for that axis there is 2 choices for gear
So on the NSP now I have an error appearing saying channel not selected.
Channels to choose from?
1 is Generic Output 1 OUT (gear Shift)
2 is Generic Output 1 Table Output (gear Shift)

Just wondering which channel do I need to select
As I can select either and table looks the same and the error disappears.

Thank you in advance please

Return to “Nexus”

Who is online

Users browsing this forum: No registered users and 1 guest