Hi all! First post but I’ve been using Haltechs for years. This is the first one I’ve installed that I just can’t get working.
Car is a tube framed open wheeled race car using a 2006 Kawasaki ZX-6RR engine with a PS1000 that I built a custom 8 tooth trigger wheel for and the stock home trigger. Cumulative counter shows a consistent 16 counts per home signal when cranking. My issue is setting base timing. When trying to get it locked at zero and confirming with a timing light, it bounces all around.
I have confirmed it has spark and fuel. When cranking it just stumbles.
With timing locked at 0 deg advance and a timing light, the mark bounces around all over the place and I can’t sort out why that’s happening.
Settings are a general multitooth trigger wheel, reluctor sensors, no filter, falling edge trigger and home.
Any thoughts on why it doesn’t consistently show TDC when timing is locked at 0 deg advance?
Video of what happens here:
Thanks for any advice!
Questions about the Platinum Sport series ECU settings or features? Ask here.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests